357217bd 357217bd

12.13.7. Removal of the external handle of a door

SEQUENCE OF WORKS

Fig. 11.31. After the sealant (2) doors at the level of the handle is taken out, access to its fixing bolt (1) with an internal hexagon will open


1. Take out a sealant 2 (fig. 11.31) doors from a groove at the level of the handle.
2. Turn off in the opening which is under the handle a bolt 1 with an internal hexagon of SW 4.
3. Press the handle lock cylinder inside and take out outside.
4. Remove the door handle with sealing laying from a support down.
5. For simplification of the return installation turn out completely outside an eccentric bolt with cross shliyets from the lower opening.
6. At first install the handle, then install the lock cylinder.
7. Tighten a bolt with an internal hexagon of SW 4.
8. Wrap an eccentric bolt with cross shliyets in the lower opening inside so that when opening the side play about 2 mm was formed.