8.3.12. Removal of the shock-absorber of a suspension bracket of a back wheel (without clearance regulator)
Here the same rule, as for forward shock-absorbers works: if necessary it is more reasonable to make pair replacement.
SEQUENCE OF WORKS
|
1. Remove a side protective upholstery in a luggage carrier.
Fig. 7.12. Weaken the top fastening of the shock-absorber. For deduction of a rod at an otvorachivaniye use a suitable key
|
2. After removal of a side upholstery it is necessary to weaken the top fastening of the shock-absorber. For deduction of a rod at an otvorachivaniye use a suitable key (fig. 7.12). On company STOA for this purpose use a special head of SW 17 with the handle welded from above in which other key for deduction of a rod of the shock-absorber is installed. If necessary it is possible to make such key independently.
3. Remove the top cup and a rubber support.
4. Remove a wheel. Council: the car has to stand on wheels, or if it is lifted, under the corresponding wheel establish props.
5. Turn off a fastening bolt on the lever. Previously uncover with it.
Fig. 7.13. A back suspension bracket and its drive in a section: 1 – top cross lever; 2 – shock-absorber; 3 – twisted spring; 4 – stretcher; 5 – reducer of the back bridge (differential); 6 – lower cross lever
|
6. Lower a wheel suspension bracket on a reliable support a little (for example, the rolling jack) and take out the shock-absorber 2 (fig. 7.13).
7. You carry out installation of the shock-absorber in the return sequence, at the same time use the new self-stopped nuts.
8. Install the shock-absorber so that its color marking was visible. Establish the top details of the shock-absorber.
9. The lower fastening tighten the moment of 55 N · m.
10. Wrap the first top nut until it does not reach the remote plug then tighten its moment 15 N · m.
11. Zakontrite the first nut the top nut also tighten its moment 30 N · m, at the same time holding the first SW 17 key.
12. Establish a wheel, bolts of fastening tighten the moment of 110 N · m.